17408
1.INSTALL TAIL EXHAUST PIPE BAFFLE SUB-ASSEMBLY (w/ Side Mudguard)
Align the keyway on a new tail exhaust pipe baffle sub-assembly with the protruding part of the exhaust tail pipe as shown in the illustration.
| *1 | Plastic Hammer |
| *a | Protruding Part |
| *b | Keyway |
Using a plastic hammer, uniformly tap in the tail exhaust pipe baffle sub-assembly.
17451
2.INSTALL EXHAUST PIPE GASKET
17410
3.INSTALL FRONT EXHAUST PIPE ASSEMBLY
Using a vernier caliper, measure the free length of the compression springs.
41.5 mm (1.634 in.)
If the length is not as specified, replace the compression spring.
Hang the front exhaust pipe assembly with the 3 exhaust pipe supports.
Install the front exhaust pipe sub-assembly onto the exhaust manifold converter sub-assembly with the 2 compression springs and 2 bolts.
| *1 | Exhaust Manifold |
| *2 | Front Exhaust Pipe Assembly |
| *3 | Gasket |
| *a | Space between flanges: 8.5 mm (0.335 in.) |
After the installation, check that the gaps between the flanges of the exhaust manifold converter sub-assembly and front exhaust pipe assembly are consistent front-to-rear and left-to-right.
17451A
4.INSTALL NO. 2 EXHAUST PIPE GASKET
17430
5.INSTALL TAIL EXHAUST PIPE ASSEMBLY
Using a vernier caliper, measure the free length of the compression springs.
38.5 mm (1.516 in.)
If the length is not as specified, replace the compression spring.
Hang the front exhaust pipe assembly with the 2 exhaust pipe supports.
Install the tail exhaust pipe assembly onto the front exhaust pipe assembly with the 2 compression springs and 2 bolts.
| *1 | Front Exhaust pipe Assembly |
| *2 | Tail Exhaust Pipe Assembly |
| *3 | Gasket |
| *a | Space between flanges: 6.5 mm (0.256 in.) |
After the installation, check that the gaps between the flanges of the exhaust manifold converter sub-assembly and front exhaust pipe assembly are consistent front-to-rear and left-to-right.
57533B
6.INSTALL FRONT FLOOR CENTER BRACE (w/ Side Mudguard)
89465A
7.INSTALL HEATED OXYGEN SENSOR
8.INSPECT FOR EXHAUST GAS LEAK
Perform "Inspection After Repairs" after repairing gas leaks in the exhaust system.
Click hereEngine / Hybrid System>1NZ-FE ENGINE CONTROL>1NZ-FE SFI SYSTEM>INITIALIZATION