89467B
1.INSTALL AIR FUEL RATIO SENSOR
| *a | Torque Wrench Fulcrum Length |
| *b | SST Fulcrum Length |
Using SST, install the air fuel ratio sensor to the exhaust manifold.
If a component has been dropped or subjected to a strong impact, replace the air fuel ratio sensor.
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 255 mm (10.0 in.)):
39 N*m (398 kgf*cm, 29 ft.*lbf)
Perform "Inspection After Repairs" after replacing the air fuel ratio sensor.
Click hereEngine / Hybrid System>2NZ-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION
Engage the 2 clamps to connect the air fuel ratio sensor wire to the wire harness clamp bracket.
Connect the air fuel ratio sensor connector.
55711
2.INSTALL OUTER COWL TOP PANEL
55722C
3.INSTALL INNER COWL TOP TO COWL BRACE
55735D
4.INSTALL FRONT AIR SHUTTER SEAL RH
55815E
5.INSTALL FRONT NO. 1 VENTILATOR SEAL
6.INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
7.INSPECT FOR EXHAUST GAS LEAK
8.PERFORM INITIALIZATION
Perform "Inspection After Repairs" after replacing the air fuel ratio sensor.
Click hereEngine / Hybrid System>2NZ-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION