Home › Vehicle Interior › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY(for Driver Side) › from 2016.09
RM19S0E _58 Vehicle Interior _051497 SEAT BELT _0248336 FRONT SEAT INNER BELT ASSEMBLY(for Driver Side) A

SEAT BELT  FRONT SEAT INNER BELT ASSEMBLY(for Driver Side)  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (w/ VSC/Built-in Type Yaw Rate Sensor)>PRECAUTION). (w/ Front Seat Side Airbag)


NOTICE:

Always use "TORX" socket wrench E10 when removing the front seat.


HINT:

The procedure described below is for the LHD. Use the same procedure for both the RHD and LHD, unless otherwise specified.


PROCEDURE

Hide 73240 1.INSTALL FRONT SEAT INNER BELT ASSEMBLY

a.
B288269E02
1.464,2.935 0.952,3.202 0.952,3.202 1.342,2.86 false 1.464,2.935 0.952,3.202 0.952,3.202 1.342,2.86 false 0.76,3.129 0.973,3.298 0.212,0.169 10 *a

Install the front seat inner belt assembly with the bolt. (for 4 Way Seat Type)

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)

NOTICE:

Do not place the front seat inner belt over the convex areas of the front seat with frame adjuster.


Text in Illustration
*a Convex


b.

Engage the clamp. (for 4 Way Seat Type)


c.
B286794E01
0.81,2.786 0.745,3.138 0.745,3.138 0.972,2.888 false 0.624,3.135 0.825,3.274 0.200,0.139 10 *a

Install the front seat inner belt assembly with the bolt. (for 6 Way Seat Type)

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)

NOTICE:

Do not place the front seat inner belt over the convex areas of the front seat with frame adjuster.


Text in Illustration
*a Convex


d.

Engage the 2 clamps. (for 6 Way Seat Type)


e.

Engage the 5 clamps.


f.

Install the front seat cushion cover with the 4 clips. (for LHD)


Hide 3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Front Seat Side Airbag)

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION