Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT AIRBAG SENSOR › from 2016.09
RM19S0E _58 Vehicle Interior _051495 SUPPLEMENTAL RESTRAINT SYSTEMS _0248325 FRONT AIRBAG SENSOR A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT AIRBAG SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (w/ VSC/Built-in Type Yaw Rate Sensor)>PRECAUTION).


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 52119A 3.REMOVE FRONT BUMPER COVER (for Sport Package)

Hide 89175 4.REMOVE AIRBAG SENSOR BRACKET

a.
B271788

Remove the 2 bolts and the airbag sensor bracket.


Hide 89173 5.REMOVE FRONT AIRBAG SENSOR

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.
B271789

Disconnect the connector from the front airbag sensor.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.


i.

Push down the white housing lock and slide the yellow CPA (At this time, the connector cannot be disconnected yet).

B445435E01
0.5,1.885 0.802,2.417 true 3.802,1.229 3.802,1.771 true 4.344,0.927 5.083,0.927 true 4.094,0.583 4.833,0.583 true 0.333,1.75 0.573,1.948 0.24,0.198 10 false *a 3.75,1.792 3.99,1.99 0.24,0.198 10 false *2 5.156,0.833 5.396,1.031 0.24,0.198 10 false *1 4.885,0.479 5.125,0.677 0.24,0.198 10 false (A)

Text in Illustration
*1 Housing Lock *2 CPA
*a Connector Lock is Released - -


ii.

Push down the white housing lock again and disconnect the connector.

NOTICE:

Do not push down the part (A) shown in the illustration when disconnecting.



iii.

After disconnecting the connector, check that the position of the white housing lock is correct as shown in the illustration.

H043303



d.
B271790

Remove the bolt and front airbag sensor.

NOTICE:

Loosen the bolt while holding the front airbag sensor because the front airbag sensor pin (stopper) is easily damaged.