Home › Engine / Hybrid System › 2NZ-FE ENGINE CONTROL › ENGINE COOLANT TEMPERATURE SENSOR › from 2016.09
RM19S0E _51 Engine / Hybrid System _051449 2NZ-FE ENGINE CONTROL _0248064 ENGINE COOLANT TEMPERATURE SENSOR A

2NZ-FE ENGINE CONTROL  ENGINE COOLANT TEMPERATURE SENSOR  INSTALLATION  


PROCEDURE

Hide 89422 1.INSTALL ENGINE COOLANT TEMPERATURE SENSOR

a.

Install a new gasket onto the engine coolant temperature sensor.


b.

Using a 19 mm socket wrench, install the engine coolant temperature sensor.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)

NOTICE:

If a component has been dropped or subjected to a strong impact, replace it.


HINT:

Perform "Inspection After Repairs" after replacing the engine coolant temperature sensor.

Click hereEngine / Hybrid System>2NZ-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION



c.

Connect the engine coolant temperature sensor connector.


Hide 17705 3.INSTALL AIR CLEANER CAP SUB-ASSEMBLY WITH NO. 1 AIR CLEANER HOSE

Hide 7.PERFORM INITIALIZATION

a.

Perform "Inspection After Repairs" after replacing the engine coolant temperature sensor.

Click hereEngine / Hybrid System>2NZ-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION