89615
1.INSTALL KNOCK SENSOR
Install the knock sensor onto the cylinder block with the nut as shown in the illustration.
Make sure that the knock sensor is in the correct position.
If a component has been dropped or subjected to a strong impact, replace it.
Perform "Inspection After Repairs" after replacing the knock sensor.
Click hereEngine / Hybrid System>2NZ-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION
Connect the knock sensor connector.
17111
2.INSTALL INTAKE MANIFOLD
3.PERFORM INITIALIZATION
Perform "Inspection After Repairs" after replacing the knock sensor.
Click hereEngine / Hybrid System>2NZ-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION