Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM › from 2017.01
RM19S0E _58 Vehicle Interior _063185 PRE-CRASH SAFETY _0307822 PRE-CRASH SAFETY SYSTEM D

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM  UTILITY  


NOTICE:
·

If "Recognition Camera/Target Position Memory" and "Recognition Camera Axis Adjust" are not performed, all of the systems using the pre-crash safety city sensor may be affected.

·

When the pre-crash safety city sensor has been replaced or the windshield glass has been replaced or removed/installed, "Recognition Camera/Target Position Memory" and "Recognition Camera Axis Adjust" must be performed. When vehicle toe-in adjustment has been performed, "Recognition Camera/Target Position Memory" and "Recognition Camera Axis Adjust" must be performed.

·

When replacing the windshield glass with the pre-crash safety city sensor installed, make sure to replace it with a genuine windshield glass made for the pre-crash safety city sensor. Windshield glass assemblies other than genuine windshield glass assemblies made for the pre-crash safety city sensor do not have a camera installation bracket. Therefore, the pre-crash safety city sensor cannot be installed. If the camera is mounted on a windshield glass that is not a genuine windshield glass made for the pre-crash safety city sensor, none of the systems using the pre-crash safety city sensor may operate properly because of the opacity of the window glass and the shape of black ceramic parts.



HINT:

The pre-crash safety city sensor recognizes the white lines in relation to the vehicle on the basis of coordinates derived from the traveling direction of the vehicle. These coordinates differ for each vehicle depending on the tolerance and installation position of the pre-crash safety city sensor to the vehicle. Therefore, pre-crash safety city sensor beam axis adjustment must be performed individually for each vehicle.


RECOGNITION CAMERA/TARGET POSITION MEMORY


a.

Before performing "Recognition Camera Axis Adjust", store the recognition camera position information, target position information and vehicle information in the pre-crash safety city sensor.

HINT:
·

Perform adjustment using "ONE TIME RECOGNITION" or "SEQUENTIAL RECOGNITION".





RECOGNITION CAMERA AXIS ADJUST


a.

After storing the "Recognition Camera/Target Position Memory", further calibrate the stored data.

HINT:
·

Since there is an error in the internal data derived from the stored recognition camera position (horizontal and vertical coordinates, etc.), calibrating the internal data captured in the recognition camera improves the recognition sensitivity of the recognition camera.

·

Perform adjustment using "ONE TIME RECOGNITION" or "SEQUENTIAL RECOGNITION".





ENTER CONTROL MODE


a.

When reproducing the problem symptom of the pre-crash safety system function, do not operate the pre-crash brake and only operate the warning (operations and buzzer sounding).

HINT:

When reproducing the problem symptom of the pre-crash safety system function, actually operating the pre-crash brake would be dangerous. To avoid this, when triggering operation of the pre-crash safety system function, do not operate the pre-crash brake and only operate the warning.




PCS IMAGE RECORD SETTING


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Chassis > PCS/LDA/RSA/LVN > Utility.


e.

Set the PCS image storage to valid or invalid.

HINT:
·

When the pre-crash brake operates, image data is stored in the pre-crash safety city sensor.

·

The stored image information cannot be viewed.





PCS IMAGE INFORMATION CLEAR


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Chassis > PCS/LDA/RSA/LVN > Utility.


e.

Clear the PCS image information stored in the pre-crash safety city sensor.



HISTORY CLEAR


a.

When the history data status is "ON", clear the history.