Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM › 2017.01–2018.06
RM19S0E _58 Vehicle Interior _063185 PRE-CRASH SAFETY _0307822 PRE-CRASH SAFETY SYSTEM C

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM  U0100  Lost Communication with ECM / PCM "A"  U0123  Lost Communication with Yaw Rate Sensor Module  U0126  Lost Communication with Steering Angle Sensor Module  U0129  Lost Communication with Brake System Control Module  U023A  Lost Communication with Front Camera Module  


DESCRIPTION

DTC Code DTC Detection Condition Trouble Area
U0100

All of the following conditions are met:

-

3 seconds have elapsed since the ignition switch to ON.

-

The battery voltage is 10 V or more for 3 seconds or more.

-

The pre-crash safety city sensor does not receive data from the ECM for 2 second or more.



·

CAN communication system

·

ECM

·

Pre-crash safety city sensor


U0123

All of the following conditions are met:

-

3 seconds have elapsed since the ignition switch to ON.

-

The battery voltage is 10 V or more for 3 seconds or more.

-

The pre-crash safety city sensor does not receive data from the airbag ECU assembly (yaw rate sensor) for 1 second or more.



·

CAN communication system

·

Airbag ECU assembly (yaw rate sensor)

·

Pre-crash safety city sensor


U0126

All of the following conditions are met:

-

3 seconds have elapsed since the ignition switch to ON.

-

The battery voltage is 10 V or more for 3 seconds or more.

-

The pre-crash safety city sensor does not receive data from the spiral cable with sensor sub-assembly (steering angle sensor) for 1 second or more.



·

CAN communication system

·

Spiral cable with sensor sub-assembly (steering angle sensor)

·

Pre-crash safety city sensor


U0129

All of the following conditions are met:

-

3 seconds have elapsed since the ignition switch to ON.

-

The battery voltage is 10 V or more for 3 seconds or more.

-

The pre-crash safety city sensor does not receive data from the brake actuator assembly (skid control ECU) for 8 seconds or more.



·

CAN communication system

·

Brake actuator assembly (skid control ECU)

·

Pre-crash safety city sensor


U023A Both of the following conditions are met:
1.

All of the following conditions are met:

-

3 seconds have elapsed since the ignition switch to ON.

-

The battery voltage is 10 V or more for 3 seconds or more.


2.

Both of the following conditions are met for 2 seconds or more:

-

The pre-crash safety city sensor can receive data from the brake actuator assembly (skid control ECU).

-

The brake actuator assembly (skid control ECU) receives a communication error signal from the pre-crash safety city sensor.



·

CAN communication system

·

Pre-crash safety city sensor



CAUTION / NOTICE / HINT

HINT:

Communication may be suspended if the temperature of the pre-crash safety city sensor is abnormal. In this case, DTC U023A will be stored, however when the temperature returns to normal, communication will return.


PROCEDURE

1.CHECK FOR DTCs (CAN COMMUNICATION SYSTEM)

b.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.



c.

Check for DTCs (See page Vehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC U0100, U0123, U0126, U0129 and U023A are not output A
DTC U0100, U0123, U0126, U0129 or U023A is output B



A

B