Use the following procedures to troubleshoot the seat belt warning system.
*: Use the intelligent tester.
| Proceed to |
|---|
| NEXT |
NEXT
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs and make a note of any codes that are output.
Clear the DTCs.
Based on the DTCs output above, try to cause output of the same CAN communication system DTC by reproducing the symptoms indicated by the DTC. Then recheck for DTCs.
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| CAN communication system DTC is output (w/o Toyota Safety Sense) | B |
| CAN communication system DTC is output (w/ Toyota Safety Sense) | C |
A
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(w/o Toyota Safety Sense)>DIAGNOSIS SYSTEM
C
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(w/ Toyota Safety Sense)>DIAGNOSIS SYSTEM
Refer to Problem Symptoms Table.
Click hereVehicle Interior>SEAT BELT>SEAT BELT WARNING SYSTEM>PROBLEM SYMPTOMS TABLE
| Proceed to |
|---|
| NEXT |
NEXT
Operation Check
Click hereVehicle Interior>SEAT BELT>SEAT BELT WARNING SYSTEM>OPERATION CHECK
Data List / Active Test
Click hereVehicle Interior>SEAT BELT>SEAT BELT WARNING SYSTEM>DATA LIST / ACTIVE TEST
Terminals of ECU
Click hereVehicle Interior>SEAT BELT>SEAT BELT WARNING SYSTEM>TERMINALS OF ECU
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT