If "Pre-crash Safety City Sensor Learning" is not performed, all of the systems using the pre-crash safety city sensor may be affected.
When the pre-crash safety city sensor has been replaced, or removed and reinstalled, "Pre-crash Safety City Sensor Learning" must be performed.
When vehicle toe-in adjustment has been performed, "Pre-crash Safety City Sensor Learning" must be performed.
When replacing the windshield glass with the pre-crash safety city sensor installed, make sure to replace it with a genuine windshield glass made for the pre-crash safety city sensor. Windshield glass assemblies other than genuine windshield glass assemblies made for the pre-crash safety city sensor do not have a camera installation bracket. Therefore, the pre-crash safety city sensor cannot be installed. If the camera is mounted on a windshield glass that is not a genuine windshield glass made for the pre-crash safety city sensor, none of the systems using the pre-crash safety city sensor may operate properly because of the opacity of the window glass and the shape of black ceramic parts.
The pre-crash safety city sensor recognizes the white lines in relation to the vehicle on the basis of coordinates derived from the traveling direction of the vehicle. These coordinates differ for each vehicle depending on the tolerance and installation position of the pre-crash safety city sensor to the vehicle. Therefore, pre-crash safety city sensor beam axis adjustment must be performed individually for each vehicle.
RECOGNITION CAMERA/TARGET POSITION MEMORY
Before performing "Recognition Camera Axis Adjust", store the recognition camera position information, target position information and vehicle information in the pre-crash safety city sensor.
For pre-crash safety city sensor adjustment procedures.
Adjustment (One time recognition)
Click hereVehicle Interior>PRE-CRASH SAFETY>FRONT SENSOR>ADJUSTMENT (ONE TIME RECOGNITION)
Adjustment (Sequential recognition)
Click hereVehicle Interior>PRE-CRASH SAFETY>FRONT SENSOR>ADJUSTMENT (SEQUENTIAL RECOGNITION)
RECOGNITION CAMERA AXIS ADJUST
After storing the "Recognition Camera/Target Position Memory", further calibrate the stored data.
Since there is an error in the internal data derived from the stored recognition camera position (horizontal and vertical coordinates, etc.), calibrating the internal data captured in the recognition camera improves the recognition sensitivity of the recognition camera.
For pre-crash safety city sensor adjustment procedures.
Adjustment (One time recognition)
Click hereVehicle Interior>PRE-CRASH SAFETY>FRONT SENSOR>ADJUSTMENT (ONE TIME RECOGNITION)
Adjustment (Sequential recognition)
Click hereVehicle Interior>PRE-CRASH SAFETY>FRONT SENSOR>ADJUSTMENT (SEQUENTIAL RECOGNITION)
HISTORY CLEAR
If the history data status is "Yes", clear the history.