Home › Engine / Hybrid System › CRUISE CONTROL › LANE DEPARTURE ALERT SYSTEM › from 2017.01
RM19S0E _51 Engine / Hybrid System _051464 CRUISE CONTROL _0307843 LANE DEPARTURE ALERT SYSTEM C

CRUISE CONTROL  LANE DEPARTURE ALERT SYSTEM  U0100  Lost Communication with ECM  U0123  Lost Communication with Yaw Rate Sensor Module  U0126  Lost Communication with Steering Angle Sensor Module  U0129  Lost Communication with Brake System Control Module  U0155  Lost Communication With Instrument Panel Cluster (IPC) Control Module  


DESCRIPTION

DTC Code DTC Detection Condition Trouble Area
U0100

Both of the following conditions are met:


1.

All of the following conditions are met:

-

3 seconds have elapsed since the ignition switch was turned ON.

-

The battery voltage is 10 V or more for 3 seconds or more.


2.

Both of the following conditions are met for 3 seconds or more:

-

The vehicle is being driven at 5 km/h (4 mph) or more.

-

The pre-crash safety city sensor does not receive data from the ECU.



·

CAN communication system

·

ECM

·

Pre-crash safety city sensor


U0123

All of the following conditions are met:

-

3 seconds have elapsed since the ignition switch was turned ON.

-

The battery voltage is 10 V or more for 3 seconds or more.

-

The pre-crash safety city sensor does not receive data from the yaw rate sensor for 1 second or more.



·

CAN communication system

·

Airbag sensor assembly (yaw rate sensor)

·

Pre-crash safety city sensor


U0126

All of the following conditions are met:

-

3 seconds have elapsed since the ignition switch was turned ON.

-

The battery voltage is 10 V or more for 3 seconds or more.

-

The pre-crash safety city sensor does not receive data from the steering sensor for 1 second or more.



·

CAN communication system

·

Spiral cable with sensor sub-assembly (steering angle sensor)

·

Pre-crash safety city sensor


U0129

All of the following conditions are met:

-

3 seconds have elapsed since the ignition switch was turned ON.

-

The battery voltage is 10 V or more for 3 seconds or more.

-

The pre-crash safety city sensor does not receive data from the skid control ECU (brake actuator assembly) for 8 seconds or more.



·

CAN communication system

·

Skid control ECU (brake actuator assembly)

·

Pre-crash safety city sensor


U0155

All of the following conditions are met:

-

3 seconds have elapsed since the ignition switch was turned ON.

-

The battery voltage is 10 V or more for 3 seconds or more.

-

The pre-crash safety city sensor does not receive data from the combination meter assembly for 80 seconds or more.



·

CAN communication system

·

Combination meter assembly

·

Pre-crash safety city sensor



PROCEDURE

1.CHECK FOR DTC (CAN COMMUNICATION SYSTEM)

b.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.




Result
Result Proceed to
CAN communication system DTCs are not output A
CAN communication system DTCs are output B


A

B