Connecting terminals TC and CG of the DLC3 causes the ECU to display the DTC by blinking the ABS warning light.
When the warning lights continue to blink, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in one or more ECUs is suspected.
Check if CAN communication system DTCs are output (See pagePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(w/o Toyota Safety Sense)>DIAGNOSIS SYSTEM).
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output | B |
A
B
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| F4-13 (TC) - F4-4 (CG) | Ignition switch ON | 11 to 14 V |
| Result | Proceed to |
|---|---|
| NG | A |
| OK | B |
| *a | Front view of DLC3 |
A
B
Turn the ignition switch off.
Disconnect the A74 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F4-13 (TC) - A74-27 (TC) | Always | Below 1 Ω |
| F4-13 (TC) - Body ground | Always | 10 kΩ or higher |
Reconnect the A74 ECM connector.
OK
NG
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F4-4 (CG) - Body ground | Always | Below 1 Ω |
OK
NG
Turn the ignition switch off.
Using SST, connect terminals TC and CG of the DLC3.
Turn the ignition switch to ON.
Check that the malfunction indicator lamp is blinking.
| *a | Front view of DLC3 |
| Result | Proceed to |
|---|---|
| Malfunction indicator lamp is blinking | A |
| Malfunction indicator lamp is not blinking | B |
A
B