The skid control ECU (brake actuator assembly) is connected to the combination meter via CAN communication.
Pressing the VSC OFF switch turns off traction control and pressing and holding this switch turns off traction and VSC controls. If traction control turns OFF, the TRC OFF indicator light will come on.
If VSC and traction control turns OFF, the TRC OFF indicator and VSC OFF indicator light will come on.
The TRC OFF indicator light is illuminated when the TRC control is prohibited by operating the VSC OFF switch.
By Pressing the VSC OFF switch for a short time, the TRC OFF mode is activated, and the TRC control is prohibited, and the TRC OFF indicator light in the combination meter is illuminated.
By pressing the VSC OFF switch for 3 seconds or longer, the VSC OFF mode is activated, the VSC and TRC controls are prohibited, and both the VSC OFF indicator light and the TRC OFF indicator light are illuminated.
When replacing the brake actuator assembly, perform zero point calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM(for Separate Type Yaw Rate Sensor)>CALIBRATION).
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
OK
NG
A
B
A
B
C
Turn the ignition switch off.
Disconnect the skid control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| A54-30 (CSW) - Body ground | VSC OFF Switch held on | Below 1 Ω |
| A54-30 (CSW) - Body ground | VSC OFF Switch off (Not pressed) | 10 kΩ or higher |
| *a | Front view of wire harness connector
(to skid control ECU) |
Reconnect the skid control ECU connector.
OK
NG
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
According to the display on the tester, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| TRC/VSC Off Mode | TRC/VSC off mode/Normal, TRC OFF, Unknown or VSC OFF | Normal: Normal mode TRC OFF: TRC OFF mode
Unknown: Unspecified VSC OFF: TRC, VSC OFF mode |
- |
Check that the mode display changes according to the VSC OFF switch operation.
Display changes according to the switch operation.
OK
NG
NEXT
Perform Active Test of the combination meter assembly using the intelligent tester (See page Vehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST).
The VSC OFF indicator light turns on or off in accordance with the intelligent tester.
OK
NG
Remove the VSC OFF switch (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VSC OFF SWITCH>REMOVAL).
Inspect the VSC OFF switch (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VSC OFF SWITCH>INSPECTION).
Reconnect the VSC OFF switch connector.
OK
NG
Disconnect the skid control ECU (brake actuator assembly) connector and the VSC OFF switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A54-30 (CSW) - F57-6 | Always | Below 1 Ω |
| F57-3 - Body ground | Always | Below 1 Ω |
| A54-30 (CSW) - Body ground | Always | 10 kΩ or higher |
Reconnect the skid control ECU (brake actuator assembly) connector and the VSC OFF switch connector.
OK
NG