Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM(for Separate Type Yaw Rate Sensor) › from 2017.01
RM19S0E _54 Brake _051475 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0248235 VEHICLE STABILITY CONTROL SYSTEM(for Separate Type Yaw Rate Sensor) J

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM(for Separate Type Yaw Rate Sensor)  Slip Indicator Light does not Come ON  


DESCRIPTION

The skid control ECU (brake actuator assembly) is connected to the combination meter via CAN communication.

The Slip indicator light blinks during VSC, TRC operation.

If any of the following is detected, the Slip indicator light remains on:

·

The skid control ECU (brake actuator assembly) connectors are disconnected from the brake actuator (skid control ECU).

·

There is a malfunction in the skid control ECU (brake actuator assembly) internal circuit.

·

There is an open in the harness between the combination meter and the skid control ECU (brake actuator assembly).

·

The VSC, TRC control system is defective.

HINT:

In some cases, the intelligent tester cannot be used when the skid control ECU (brake actuator assembly) is abnormal.



CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the brake actuator assembly, perform zero point calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM(for Separate Type Yaw Rate Sensor)>CALIBRATION).

·

Inspect the fuses for circuits related to this system before performing the following inspection procedure.



PROCEDURE

2.CHECK SLIP INDICATOR LIGHT
a.

Disconnect the skid control ECU connector.


b.

Turn the ignition switch to ON.


c.

Check that the Slip indicator light comes on.



OK

NG

3.READ VALUE USING INTELLIGENT TESTER (SLIP INDICATOR LIGHT)