Home › General › INTRODUCTION › REPAIR INSTRUCTION › from 2017.01
RM19S0E _V1 General _051444 INTRODUCTION _0247917 REPAIR INSTRUCTION D

INTRODUCTION  REPAIR INSTRUCTION  INITIALIZATION  


PROCEDURES NECESSARY WHEN BATTERY TERMINAL IS DISCONNECTED/RECONNECTED


Necessary Procedures Effect/Inoperative Function when Necessary Procedures not Performed Link
Memorize steering angle neutral point Lane departure alert system (Click here)
Pre-crash safety system


PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED


Procedures Necessary when ECU or Other Parts are Replaced
Replacement Part Necessary Procedure Effect or Inoperative Function when Necessary Procedure is not Performed See Page
ECM Vehicle Identification Number (VIN) registration DTC P0630 is output (Click here)for Registration (1NZ-FE)
(Click here)for Registration (2NZ-FE)
ECU communication ID registration Engine start Refer to the Service Bulletin for the registration procedure.
·

Throttle body with motor assembly or any throttle body components

·

Throttle body is cleaned

·

Engine assembly

·

Cylinder head

·

Camshaft (for intake side)

·

Camshaft timing gear assembly

·

Piston or piston ring

·

Mass air flow meter

·

Fuel injector assembly

·

Fuel pump

·

Air fuel ratio sensor

·

Engine coolant temperature sensor

·

Spark plug

·

No.1 ignition coil

·

Knock sensor

·

Air leaks from intake system

·

Gas leaks from exhaust system


Inspection after repairs - (Click here)for Initialization (1NZ-FE)
(Click here)for Initialization (2NZ-FE)
·

Pre-crash safety city sensor*4

·

Windshield glass*4


·

Recognition camera/target position memory

·

Recognition camera axis adjust


·

Lane departure alert system

·

Pre-crash safety system

·

Automatic high beam system


(Click here)
Automatic transaxle assembly, engine assembly or ECM
·

Reset memory (AT initialization)

·

Road test


Large shift shock (Click here)for Initialization (U340E)
(Click here)for Initialization (U441E)
Yaw rate sensor (Airbag sensor assembly)*1 Yaw rate and deceleration sensor zero point calibration
·

Warning light comes on

·

The deterioration of fuel efficiency


(Click here)for Calibration (vehicle stability control system)
Yaw rate deceleration sensor (Yaw rate sensor)*2 Yaw rate and deceleration sensor zero point calibration
·

Warning light comes on

·

The deterioration of fuel efficiency


(Click here)for Calibration (vehicle stability control system)
Brake actuator assembly (Skid control ECU) Yaw rate and deceleration sensor zero point calibration
·

Warning light comes on

·

The deterioration of fuel efficiency


(Click here)for Calibration (vehicle stability control system)*1
(Click here)for Calibration (vehicle stability control system)*2
·

Power steering ECU assembly

·

Power steering motor assembly

·

Steering column assembly (containing the torque sensor)


·

Torque sensor zero point calibration

·

Assist map writing


·

Warning light comes on

·

Power assist stops


(Click here)for Calibration (power steering system)
·

Door control receiver

·

Key


Registration of recognition codes Wireless door lock control system (Click here)for Registration (wireless door lock control system)
·

Transponder key ECU

·

Key

·

ECM


·

ECU communication ID registration

·

Key code registration


Engine start Refer to the Service Bulletin for the registration procedure.
Power window regulator motor Motor initialization
·

Jam protection function

·

Power window control system


(Click here)for Initialization (Power window control system)
·

Headlight leveling ECU assembly*3

·

Rear height control sensor sub-assembly*3


Perform Headlight leveling ECU initialization Automatic headlight beam level control function (Click here)for Initialization (Automatic headlight beam level control system)

*1: for Built-in Type Yaw Rate Sensor

*2: for Separate Type Yaw Rate Sensor

*3: w/ Automatic Headlight Beam Level Control System

*4: w/ Toyota Safety Sense