Home › Power Source / Network › NETWORKING › NETWORK GATEWAY ECU › from 2017.01
RM19S0E _57 Power Source / Network _051489 NETWORKING _0309292 NETWORK GATEWAY ECU A

NETWORKING  NETWORK GATEWAY ECU  INSTALLATION  


PROCEDURE

Hide 89111 1.INSTALL CENTRAL GATEWAY ECU (NETWORK GATEWAY ECU)

a.

Connect the connector.


b.

Engage the hook to install the central gateway ECU (network gateway ECU).


c.

Install the screw.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)

NOTICE:

If it is difficult to tighten the screw to the specified torque, replace the screw with a Part No. 90159-70003 screw.



Hide 55302A 2.INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY