Use these procedures to troubleshoot the key reminder warning system.
*: Use the intelligent tester.
| Proceed to |
|---|
| NEXT |
NEXT
Check the battery voltage.
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| Proceed to |
|---|
| NEXT |
NEXT
Use an intelligent tester to check if the CAN communication system is functioning normally.
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output | B |
A
B
| Result | Proceed to |
|---|---|
| Fault is not listed on Problem Symptoms Table | A |
| Fault is listed on Problem Symptoms Table | B |
A
B
Terminals of ECU.
Click hereVehicle Interior>DOOR LOCK>KEY REMINDER WARNING SYSTEM>TERMINALS OF ECU
Data list/Active test.
Click hereVehicle Interior>DOOR LOCK>KEY REMINDER WARNING SYSTEM>DATA LIST / ACTIVE TEST
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT