Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › BACK DOOR OUTSIDE GARNISH › from 2017.01
RM19S0E _59 Vehicle Exterior _051507 EXTERIOR PANELS / TRIM _0311472 BACK DOOR OUTSIDE GARNISH A

EXTERIOR PANELS / TRIM  BACK DOOR OUTSIDE GARNISH  INSTALLATION  


PROCEDURE

Hide 76825D 1.INSTALL NO. 1 BACK DOOR OUTSIDE GARNISH PROTECTOR

a.

Clean the attachment surface.

i.

Using a piece of cloth, rub the double-sided tape off the back door outside garnish sub-assembly.

NOTICE:
·

Installing the No. 1 back door outside garnish protector while old double-sided tape remains can cause adhesion failure.

·

Using a screwdriver or similar tool to remove the old tape can damage the surface and cause adhesion failure.




ii.

Using a non-residue solvent, clean the attachment surface.



b.

Remove the peeling paper on a new No. 1 back door outside garnish protector.

NOTICE:

After removing the release paper, keep the exposed adhesive free from foreign matter.



c.
B465413C02
2.188,1.667 0.667,1.75 0.667,1.75 0.938,0.958 false 0.469,1.667 0.781,1.823 0.313,0.156 10 false *a
*a Mark-off Line


Install the 2 No. 1 back door outside garnish protectors as shown in the illustration.

NOTICE:

Press the double-sided tape on the No. 1 back door outside garnish protector firmly to attach.


HINT:
·

Align the No. 1 back door outside garnish protector with the mark-off line of the back door outside garnish sub-assembly.

·

Use the same procedure for both sides.




Hide 76821 2.INSTALL BACK DOOR GARNISH MOULDING UPPER PROTECTOR

a.

Clean the attachment surface.

i.

Using a piece of cloth, rub the double-sided tape off the back door outside garnish sub-assembly.

NOTICE:
·

Installing the No. 1 back door outside garnish protector while old double-sided tape remains can cause adhesion failure.

·

Using a screwdriver or similar tool to remove the old tape can damage the surface and cause adhesion failure.




ii.

Using a non-residue solvent, clean the attachment surface.



b.

Remove the peeling paper on a new back door garnish moulding upper protector.

NOTICE:

After removing the release paper, keep the exposed adhesive free from foreign matter.



c.
B465412C02
0.188,0.667 0.438,0.417 false 2.99,0.385 3.24,0.635 false 0.51,0.333 0.823,0.49 0.313,0.156 10 false *a 2.781,0.302 3.094,0.458 0.313,0.156 10 false *a
*a Mark-off Line


Install the back door garnish moulding upper protector as shown in the illustration.

NOTICE:

Press the double-sided tape on the back door garnish moulding upper protector firmly to attach.



Hide 76801 3.INSTALL BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY

a.

Engage the 11 clips and install the back door outside garnish sub-assembly.


b.

Install the 8 bolts.

Torque:
4.9 N*m (50 kgf*cm, 43 in.*lbf)


Hide 75741E 4.INSTALL SYMBOL EMBLEM

Hide 81590A 5.INSTALL REAR LIGHT ASSEMBLY LH

Hide 81580D 6.INSTALL REAR LIGHT ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.