Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM
RM19S0E _55 Steering _051480 POWER ASSIST SYSTEMS _0248253 POWER STEERING SYSTEM C

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  C1517  Torque Hold  


DESCRIPTION

While DTC C1517 is detected, power assist is stopped due to fail-safe operation.

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Return-to-normal Condition
C1517 Torque Hold Temporary control due to malfunction related to torque sensor continues for long time Power steering ECU assembly EPS warning light: Comes on Ignition switch ON again

WIRING DIAGRAM

C375647E10
0.271,3.01 2.323,3.344 2.052,0.333 10 false Torque Sensor (Steering Column Sub-assembly) 5.854,0.615 6.167,0.813 0.313,0.198 10 false 5V 5.083,0.833 5.698,1.031 0.615,0.198 10 false TRQV 5.115,1.406 5.729,1.604 0.615,0.198 10 false TRQ1 5.115,1.896 5.729,2.094 0.615,0.198 10 false TRQ2 5.083,2.26 5.698,2.458 0.615,0.198 10 false TRQG 4.885,0.813 5.042,1.01 0.156,0.198 10 false 8 4.885,1.26 5.042,1.458 0.156,0.198 10 false 9 4.875,1.781 5.031,1.979 0.156,0.198 10 false 1 4.885,2.25 5.042,2.448 0.156,0.198 10 false 2 4.865,2.958 5.177,3.156 0.313,0.198 10 false z6 4.875,3.104 7.146,3.438 2.271,0.333 10 false Power Steering ECU Assembly

CAUTION / NOTICE / HINT

NOTICE:

If the power steering ECU assembly has been replaced, perform assist map writing and torque sensor zero point calibration.

Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION


PROCEDURE

1.CHECK FOR DTC
a.

Check for DTCs.

Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR

OK:

DTC C1511 and C1512 are not output.


Result
Result Proceed to
DTCs C1511 and C1512 are not output (for LHD) A
DTCs C1511 and C1512 are not output (for RHD) B
DTC C1511 is output C
DTC C1512 is output D



A

REPLACE POWER STEERING ECU ASSEMBLY

B

REPLACE POWER STEERING ECU ASSEMBLY

C

D