Home › Vehicle Interior › PRE-CRASH SAFETY › CAMERA HEATER › from 2018.06
RM19S0E _58 Vehicle Interior _063185 PRE-CRASH SAFETY _0359492 CAMERA HEATER A

PRE-CRASH SAFETY  CAMERA HEATER  REMOVAL  


PROCEDURE

Hide 88181 1.REMOVE PRE-CRASH SAFETY CITY SENSOR

Hide 88186 2.REMOVE PRE-CRASH SAFETY CITY HEATER WIRE

a.
E357212C01
0.438,0.333 0.708,0.479 false 1.542,1.094 1.594,1.406 1.594,1.406 1.771,0.958 true 0.24,0.177 0.552,0.375 0.313,0.198 10 false *a 1.531,1.438 1.844,1.635 0.313,0.198 10 false *b
*a Clamp
*b Guide


Disengage the clamp and 2 guides.


b.
E401123

Disconnect the 2 connectors to remove the pre-crash safety city heater wire.


Hide 88185 3.REMOVE PRE-CRASH SAFETY CITY HEATER

HINT:
·

Perform this step only when replacement of the pre-crash safety city heater is necessary, because it is a non-reusable part.

·

If the pre-crash safety city heater has been removed, replace it with a new one.



a.

If the ambient temperature is lower than 15°C:

i.

Using a heat light, heat the pre-crash safety city heater and windshield glass surface.

Heating Temperature
Item Temperature
Pre-crash safety city heater 15 to 80°C (59 to 176°F)
Windshield glass 15 to 80°C (59 to 176°F)

CAUTION:
·

Do not touch the heat light and heated parts, touching the heat light may result in burns.

·

Touching heated parts for a long time may result in burns.



NOTICE:

Do not heat the pre-crash safety city heater or windshield glass excessively.




b.
E357198

Using a plier, and remove the pre-crash safety city heater as shown in the illustration.