| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| U0100 | The pre-crash safety city sensor is unable to receive data from the ECM continuously for 9 seconds or more. | ·
CAN communication system ·
ECM ·
Pre-crash safety city sensor |
| U0123 | The pre-crash safety city sensor is unable to receive data from the ECM continuously for 9 seconds or more. | ·
CAN communication system ·
Airbag ECU assembly (yaw rate sensor) ·
Pre-crash safety city sensor |
| U0126 | The pre-crash safety city sensor is unable to receive data from the spiral with sensor cable sub-assembly (steering angle sensor) continuously for 1 second or more. | ·
CAN communication system ·
Spiral cable with sensor sub-assembly (steering angle sensor) ·
Pre-crash safety city sensor |
| U0129 | The pre-crash safety city sensor is unable to receive data from the brake actuator assembly (skid control ECU) for 5 seconds or more. | ·
CAN communication system ·
Brake actuator assembly (skid control ECU) ·
Pre-crash safety city sensor |
| U0155 | The pre-crash safety city sensor is unable to receive data from the combination meter assembly continuously for 80 seconds or more. | ·
CAN communication system ·
Combination meter assembly ·
Pre-crash safety city sensor |
| U023A | The brake actuator assembly (skid control ECU) is unable to receive data from the pre-crash safety city sensor for 2.24 seconds or more. | ·
CAN communication system ·
Pre-crash safety city sensor |
Communication may be suspended if the temperature of the pre-crash safety city sensor is abnormal. In this case, DTC U023A will be stored, however when the temperature returns to normal, communication will return.
Clear the DTCs (See page Vehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR).
Make sure that the DTC detection conditions are met.
If the detection conditions are not met, the system cannot detect the malfunction.
Check for DTCs (See page Vehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC U0100, U0123, U0126, U0129, U0155 and U023A are not output | A |
| DTC U0100, U0123, U0126, U0155 or U023A is output | B |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B