DTC C1516 Torque Sensor Zero Point Adjustment Incomplete |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1516 | Torque sensor zero point calibration not completed successfully. |
|
| 1.CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 2.PERFORM ZERO POINT CALIBRATION (TORQUE SENSOR) |
Perform torque sensor zero point calibration (Click here ).
| NEXT | |
| 3.CONFIRM DTC |
Check for DTCs (Click here).
| Result | Proceed to |
| DTC is still output even after performing torque sensor zero point calibration 3 times*1. | A |
| DTC is still output even after performing torque sensor zero point calibration once or twice*2. | B |
| Normal system code is output. | C |
|
| ||||
|
| ||||
| A | |
| 4.REPLACE POWER STEERING ECU ASSEMBLY |
Replace the power steering ECU assembly (Click here).
| NEXT | |
| 5.PERFORM ZERO POINT CALIBRATION (TORQUE SENSOR) |
Perform the torque sensor zero point calibration (Click here).
| NEXT | |
| 6.CONFIRM DTC |
Check for DTCs (Click here).
| Result | Proceed to |
| DTC is still output even after performing torque sensor zero point calibration 3 times*1. | A |
| DTC is still output even after performing torque sensor zero point calibration once or twice*2. | B |
| Normal system code is output. | C |
|
| ||||
|
| ||||
| A | ||
| ||