DTC P0010 Camshaft Position "A" Actuator Circuit (Bank 1) |

| DTC No. | DTC Detection Condition | Trouble Area |
| P0010 | Open or short in OCV (for intake camshaft) circuit (1 trip detection logic) |
|

| 1.CHECK DTC (OPERATE OCV) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON and turn the Techstream on.
Clear DTCs after recording the freeze frame data and DTCs.
Start the engine.
Allow the engine to idle and check for DTCs.
Check that P0010 is present.
|
| ||||
| OK | |
| 2.INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY |
![]() |
Disconnect the C24 OCV connector.
Measure the resistance between the terminals of the OCV.
Reconnect the OCV connector.
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (OCV - ECM) |
![]() |
Disconnect the C24 OCV connector.
Disconnect the C20 ECM connector.
Check the resistance.
| Tester Connections | Specified Conditions |
| OC1+ (C24-1) - OC1+ (C20-100) | Below 1 Ω |
| OC1- (C24-2) - OC1- (C20-123) |
| Tester Connections | Specified Conditions |
| OC1+ (C24-1) or OC1+ (C20-100) - Body ground | 10 kΩ or higher |
| OC1- (C24-2) or OC1- (C20-123) - Body ground |
Reconnect the OCV connector.
Reconnect the ECM connector.
|
| ||||
| OK | ||
| ||