DTC P0010 Camshaft Position "A" Actuator Circuit (Bank 1) |

| DTC No. | DTC Detection Condition | Trouble Area |
| P0010 | Open or short in camshaft timing oil control valve assembly circuit (1 trip detection logic) |
|
| Related DTCs | P0010 Camshaft Timing Oil Control Valve Range Check |
| Required Sensors/Components (Main) | Camshaft timing oil control valve assembly |
| Required Sensors/Components (Related) | - |
| Frequency of Operation | Continuous |
| Duration | 1 second |
| MIL Operation | Immediate |
| Sequence of Operation | None |
| Monitor runs whenever following DTCs not present | None |
| All of following conditions met | - |
| Starter | OFF |
| Ignition switch | ON |
| Time after ignition switch off to ON | 0.5 seconds or more |
| One of following conditions met | - |
| A. All of following conditions met | - |
| Battery voltage | 11 V or more, and less than 13 V |
| Target duty cycle | Less than 70% |
| B. All of following conditions met | - |
| Battery voltage | 13 V or more |
| Target duty cycle | Less than 80% |
| Current cut status | Not cut |
| Output duty cycle | 100% or more |
| Output duty cycle | 3% or less |
| Output duty cycle | More than 3%, and less than 100% |
| Techstream Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|

| 1.READ DTC OUTPUT |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Clear the DTC after recording the freeze frame data and DTC.
Turn the ignition switch off.
Start the engine and allow the engine to idle.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read DTCs.
| Result | Proceed to |
| DTC P0010 is output | A |
| DTC is not output | B |
|
| ||||
| A | |
| 2.INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY |
Inspect the camshaft timing oil control valve assembly (Click here).
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY - ECM) |
Disconnect the camshaft timing oil control valve assembly connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| C60-1 - C51-75 (OC1+) | Always | Below 1 Ω |
| C60-2 - C51-74 (OC1-) | Always | Below 1 Ω |
| C60-1 or C51-75 (OC1+) - Body ground | Always | 10 kΩ or higher |
| C60-2 or C51-74 (OC1-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||