Home › Vehicle Interior › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY (for Hatchback Driver Side)

FRONT SEAT INNER BELT ASSEMBLY (for Hatchback Driver Side) > REMOVAL


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here). (w/ Front Seat Side Airbag)

NOTICE:
Always use E10 "TORX" socket wrench when removing the front seat.



1. PRECAUTION (w/ Front Seat Side Airbag)

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Front Seat Side Airbag)

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE FRONT SEAT ASSEMBLY
(Click here)


4. REMOVE FRONT SEAT CUSHION COVER


    B332510
  1. Remove the 2 clips.

  1. Disengage the 2 hooks to remove the front seat cushion cover.



5. REMOVE FRONT SEAT INNER BELT ASSEMBLY


  1. for 6 Way Seat Type:



      B332514
    1. Disengage the 4 clamps.



    2. B286761
    3. Disengage the 2 clamps.

    4. Remove the nut and front seat inner belt assembly.



  1. for 4 Way Seat Type:



      B332515
    1. Disengage the 3 clamps.



    2. B288263
    3. Disengage the clamp.

    4. Remove the nut and front seat inner belt assembly.