DTC P0128 Coolant Thermostat (Coolant Temperature Below Thermostat Regulating Temperature) |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0128 |
|
|

| Related DTCs | P0128: Coolant Thermostat |
| Required Sensors/Components (Main) | Thermostat Engine coolant temperature sensor |
| Required Sensors/Components (Related) | Intake air temperature sensor Vehicle speed sensor |
| Frequency of Operation | Once per driving cycle |
| Duration | 480 seconds: for Automatic Transaxle 520 seconds: for Manual Transaxle |
| MIL Operation | 2 driving cycles |
| Sequence of Operation | None |
| Monitor runs whenever following DTCs not present | P0010 (Camshaft Timing Oil Control Valve) P0011 (VVT System - Advance) P0012 (VVT System - Retard) P0016 (VVT System - Misalignment) P0031, P0032, P101D (Air Fuel Ratio Sensor Heater) P2195, P2196, P2237, P2238, P2239, P2252, P2253, P014C, P014D, P015A, P015B (Air Fuel Ratio Sensor) P0102, P0103 (Mass Air Flow Sensor) P0112, P0113 (Intake Air Temperature Sensor) P0115, P0117, P0118 (Engine Coolant Temperature Sensor) P0120, P0121, P0122, P0123, P0220, P0222, P0223, P2135 (Throttle Position Sensor) P0171, P0172 (Fuel System) P0301 - P0304 (Misfire) P0335 (Crankshaft Position Sensor) P0340 (Camshaft Position Sensor) P0351 - P0354 (Igniter) P0500 (Vehicle Speed Sensor) P219A (Air Fuel Ratio Imbalance) |
| Battery voltage | 11 V or higher |
| Either of following conditions met: | 1 or 2 |
| 1. All of following conditions met: | - |
| -15 to 7°C (-27 to 12.6°F) |
| -10 to 56°C (14 to 133°F) |
| -10 to 56°C (14 to 133°F) |
| 2. All of following conditions met: | - |
| Higher than 7°C (12.6°F) |
| 56°C (133°F) or less |
| -10°C (14°F) or higher |
| Accumulated time at vehicle speed of 128 km/h (80 mph) or more | Less than 20 seconds |
| Duration that both of following conditions met | 5 seconds or more |
| (a) Estimated engine coolant temperature | 75°C (167°F) or higher |
| (b) Engine coolant temperature sensor output | Below 75°C (167°F) |

| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0128) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read DTCs.
| Result | Proceed to |
| DTC P0128 is output | A |
| DTC P0128 and other DTCs are output | B |
|
| ||||
| A | |
| 2.CHECK COOLING SYSTEM |
Check for defects in the cooling system that might cause the system to be too cold, such as abnormal cooling fan operation or any modifications.
|
| ||||
| OK | |
| 3.INSPECT THERMOSTAT |
Inspect the thermostat (Click here).
|
| ||||
| OK | ||
| ||