Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT PASSENGER AIRBAG ASSEMBLY (for Hatchback)

FRONT PASSENGER AIRBAG ASSEMBLY (for Hatchback) > REMOVAL


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



3. REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY
(Click here)


4. REMOVE NO. 2 HEATER TO REGISTER DUCT SUB-ASSEMBLY


    B284251
  1. Remove the 4 <A> screws, disengage the 4 guides and remove the heater to register duct.



5. REMOVE INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY


    B288132E01
  1. Remove the 2 screws.

  1. Disengage the clamp.

  1. Disengage the 3 hooks A.

  1. Disengage the 3 hooks B to remove the instrument panel passenger airbag assembly as shown in the illustration.



6. REMOVE FRONT PASSENGER AIRBAG CONNECTOR COVER


    B288133
  1. Disengage the 8 claws to remove the front passenger airbag connector cover.



7. REMOVE NO. 2 INSTRUMENT PANEL WIRE


B288134E01
  1. Using a thin-bladed screwdriver with its tip wrapped with protective tape, 3 release the locking buttons.

  1. Disconnect the vent hole connector.

  1. Disconnect the 2 airbag connectors and remove the No. 2 instrument panel wire.
    Text in illustration 
    *1
    Protective Tape
    *2
    Locking Button
    *3
    Vent Hole Connector
    *4
    Airbag Connector