FRONT AIRBAG SENSOR (for Sedan) > INSTALLATION |
| 1. INSTALL FRONT AIRBAG SENSOR |
![]() |
Confirm that the ignition switch is turned to off.
Confirm that the negative battery terminal is detached.
Connect the airbag connector.
Check that the CPA is in the provisionally locked condition.
![]() |
Push the CPA until it makes a click sound.
| *a | Conform |
Confirm that the rear side of the housing and the CPA rear surface are tightly fitted together.
Install the front airbag sensor with the 2 bolts.
Confirm that there is no looseness by shaking the front airbag sensor.
| 2. INSTALL FRONT BUMPER COVER |
| 3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 4. INSPECT SRS WARNING LIGHT |