Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT AIRBAG SENSOR (for Sedan)

FRONT AIRBAG SENSOR (for Sedan) > REMOVAL


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).

HINT:
The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



3. REMOVE FRONT BUMPER COVER
(Click here)


4. REMOVE FRONT AIRBAG SENSOR


B106581E01

CAUTION:
Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.

  1. Remove the 2 bolts.

  1. Disengage the 2 claws and remove the front airbag sensor.



    B106582E04
  1. Disconnect the airbag connector.
    Text in Illustration 
    *a
    Housing
    *b
    CPA
    *c
    Primary Locked State

    NOTICE:
    1. Do not disconnect the airbag connector by pulling the wire harness.
    2. Release the lock without holding the upper side of CPA.


    1. While pushing the housing, slide only the CPA backward (from a provisionally locked state).

    2. Detach the connector while pushing the housing in the provisionally locked state.

      NOTICE:
      1. Do not disconnect the airbag connector by pulling the wire harness.
      2. Release the lock without holding the upper side of CPA.



    3. B106583
    4. After detaching the connector, confirm that the CPA protrudes beyond the rear of the housing.