Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM (for Hatchback without VSC)

AIRBAG SYSTEM (for Hatchback without VSC) > TC and CG Terminal Circuit


DESCRIPTION

DTC output mode is set by connecting terminals TC and CG of the DLC3.
The DTCs are displayed by blinking the SRS warning light.

HINT:
  1. Make sure that DTCs which relate to the CAN communication system are not output. If any of these DTCs are output, check the CAN communication system (Click here).
  2. When a warning light keeps blinking, a short to ground in the wiring of terminal TC of the DLC3 or an internal ground short in an ECU is suspected.
  3. The DTC output mode signal is transmitted through the CAN to each ECU including the airbag sensor assembly. Thus if no systems enter DTC output mode, the ECM may have a malfunction.


WIRING DIAGRAM


C243297E06


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (DLC3 - ECM)
  1. Turn the ignition switch off.

  1. Disconnect the connector from the ECM.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D102-13 (TC) -
    A72-23 (TC)
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (CG OF DLC3 - BODY GROUND)


    C196989E25
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D102-4 (CG) -
    Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *1
    DLC3



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (TC OF ECM)


    A246776E04
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A72-23 (TC) -
    Body ground
    Always
    1 MΩ or higher

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to ECM)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK ECM
  1. Replace the ECM (Click here).

  1. Check for DTCs of the ECM.
    Result 
    Result
    Proceed to
    Normal code is output
    A
    DTC is output
    B
    DTC output mode is set (except airbag sensor assembly)
    C



B
GO TO INSPECTION PROCEDURE OF DTC OUTPUT (Click here)

C
REPLACE AIRBAG SENSOR ASSEMBLY (Click here)
A

END (ECM WAS DEFECTIVE)