DTC C1427 Motor Malfunction |
| DTC NO. | DTC Detection Condition | Trouble Area |
| C1427 | The actuator pump motor does not operate properly. |
|
| 1.PERFORM ACTIVE TEST USING TECHSTREAM (ABS MOTOR RELAY) |
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Chassis / ABS/VSC/TRAC / Active Test.
According to the display on the Techstream, perform the Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Motor Relay | ABS motor relay | Relay ON / OFF | Operating sound of motor can be heard. |
Check for operating sound of the ABS motor relay when operating it with the Techstream.
| Result | Proceed to |
| Operating sound is not heard | A |
| Operating sound is heard | B |
|
| ||||
| A | |
| 2.CHECK HARNESS AND CONNECTOR (GND2 TERMINAL) |
Turn the ignition switch off.
Make sure that there is no looseness at the locking part and the connecting part of the connectors.
Disconnect the A15 brake actuator assembly (skid control ECU) connector.
![]() |
Check the connector case and terminals for deformation and corrosion.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A15-13 (GND2) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Brake Actuator Assembly (Skid Control ECU)) |
Reconnect the A15 brake actuator assembly (skid control ECU) connector.
|
| ||||
| OK | |
| 3.RECONFIRM DTC |
Turn the ignition switch off.
Clear the DTCs (Click here).
Start the engine.
Drive the vehicle at a speed of 20 km/h (12 mph) or more for 30 seconds or more.
Check if the same DTC is recorded (Click here).
| Result | Proceed to |
| DTC (C1427) is not output | A |
| DTC (C1427) is output | B |
|
| ||||
| A | ||
| ||