DTC C0273 Open in ABS Motor Relay Circuit |
DTC C0274 Short in ABS Motor Relay Circuit |
| DTC NO. | DTC Detection Condition | Trouble Area |
| C0273 | When either of the following is detected:
|
|
| C0274 | When the motor relay is OFF, the motor relay remains closed for 4 seconds or more. | Brake actuator assembly |

| 1.CHECK HARNESS AND CONNECTOR (+BM TERMINAL) |
Turn the ignition switch off.
Make sure that there is no looseness at the locking part and the connecting part of the connectors.
Disconnect the A15 brake actuator assembly (skid control ECU) connector.
![]() |
Check the connector case and terminals for deformation and corrosion.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A15-24 (+BM) - Body ground | Always | 11 to 14 V |
| *a | Front view of wire harness connector (to Brake Actuator Assembly (Skid Control ECU)) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (GND2 TERMINAL) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A15-13 (GND2) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Brake Actuator Assembly (Skid Control ECU)) |
Reconnect the A15 brake actuator assembly (skid control ECU) connector.
|
| ||||
| OK | |
| 3.RECONFIRM DTC |
Clear the DTC (Click here).
Start the engine.
Drive the vehicle at the speed of 20 km/h (12 mph) or more for 30 seconds or more.
Check if the same DTC is recorded (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | ||
| ||