Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM (for Sedan)

ANTI-LOCK BRAKE SYSTEM (for Sedan) > ABS Warning Light does not Come ON


DESCRIPTION

Refer to ABS Warning Light Remains ON .

WIRING DIAGRAM

Refer to ABS Warning Light Remains ON .

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check if CAN communication system DTCs are output (Click here).
    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2.CHECK ABS WARNING LIGHT
  1. Disconnect the A15 brake actuator assembly (skid control ECU) connector.

  1. Turn the ignition switch to ON.

  1. Check that the ABS warning light comes on.

    OK:
    ABS warning light comes on.

  1. Reconnect the A15 brake actuator assembly (skid control ECU) connector.



NG
Go to step 3
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)  

3.PERFORM ACTIVE TEST USING TECHSTREAM (Indicat. Lamp ABS)
  1. Turn the ignition switch off.

  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Body Electrical / Combination Meter / Active Test.

  1. According to the display on the Techstream, perform the Active Test.

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Indicat. Lamp ABS
    ABS warning light
    OFF/ON
    Perform the test with the vehicle stopped and the engine idling

  1. Check that the ABS warning light on the combination meter turns on or off in accordance with the tester operation.

    OK:
    The ABS warning light turns on or off in accordance with the tester operation.



NG
GO TO METER / GAUGE SYSTEM (Click here)
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)