Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM (for Sedan)

ANTI-LOCK BRAKE SYSTEM (for Sedan) > TC and CG Terminal Circuit

for Preparation Click here


DESCRIPTION

Connecting terminals TC and CG of the DLC3 causes the ECU to display the DTC by blinking the ABS warning light.

WIRING DIAGRAM


C240194E09

HINT:
When the warning lights continue to blink, there may be a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in one or more ECUs.


INSPECTION PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check if CAN communication system DTCs are output (Click here).
    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2.INSPECT DLC3


    C146309E96
  1. Turn the ignition switch to ON.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    D15-13 (TC) - D15-4 (CG)
    Ignition switch ON
    11 to 14 V

    Text in Illustration 
    *a
    Front view of DLC3
    Result 
    Result
    Proceed to
    NG
    A
    OK
    B



B
Go to step 5
A


3.CHECK HARNESS AND CONNECTOR (TC of DLC3 - ECM)
  1. Turn the ignition switch off.

  1. Disconnect the A21 ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D15-13 (TC) - A21-27 (TC)
    Always
    Below 1 Ω
    D15-13 (TC) - Body ground
    Always
    10 kΩ or higher

  1. Reconnect the A58 ECM connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (CG of DLC3 - BODY GROUND)
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D15-4 (CG) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.INSPECT ECM (TC of DLC3 INPUT)
SST
09843-18040  


    C146309E96
  1. Turn the ignition switch off.

  1. Using SST, connect terminals TC and CG of the DLC3.

  1. Turn the ignition switch to ON.

  1. Check that the Malfunction Indicator Lamp (MIL) is blinking.
    Text in Illustration 
    *a
    Front view of DLC3
    Result 
    Result
    Proceed to
    Malfunction Indicator Lamp (MIL) is blinking
    A
    Malfunction Indicator Lamp (MIL) is not blinking
    B



B
SFI SYSTEM
A

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)