TIRE PRESSURE WARNING SYSTEM (for Hatchback) > DTC CHECK / CLEAR |
| CHECK DTC (for TIRE PRESSURE WARNING ECU AND RECEIVER) (USING THE TECHSTREAM) |
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Chassis / Tire Pressure Monitor / Trouble Codes.
Read the DTCs.
| CHECK DTC (for TIRE PRESSURE WARNING ECU AND RECEIVER) (USING SST CHECK WIRE) |
![]() |
Turn the ignition switch off.
Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.
Turn the ignition switch to ON.
Read and record any DTCs from the tire pressure warning light on the combination meter assembly. Refer to the illustration for examples of a normal system code and codes 13 and 33.
| Trouble Area | See page |
| Tire pressure warning light circuit |
Click here
|
| TC and CG terminal circuit |
Click here
|
| *1 | DLC3 |
| *2 | Tire Pressure Warning Light |
| *a | Normal System Code |
| *b | ON |
| *c | OFF |
| *d | 0.25 seconds |
| *e | Code 13 and 33 |
| *f | 0.5 seconds |
| *g | 2.5 seconds |
| *h | 1.5 seconds |
| *i | 4.5 seconds |
| *j | Repeat |
Refer to the Diagnostic Trouble Code Chart (Click here) for DTC information.
After completing the check, turn the ignition switch off and remove SST from the DLC3.
| CHECK DTC (for MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)) |
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Main Body / Trouble Codes.
Read the DTCs.
| CLEAR DTC (for TIRE PRESSURE WARNING ECU AND RECEIVER) |
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Chassis / Tire Pressure Monitor / Trouble Codes.
Clear DTCs following the prompts on the Techstream screen.
| CLEAR DTC (for MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)) |
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Main Body / Trouble Codes.
Clear DTCs following the prompts on the Techstream screen.