Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM (for Hatchback)

TIRE PRESSURE WARNING SYSTEM (for Hatchback) > Tire Pressure Warning Light Circuit


DESCRIPTION

If the tire pressure warning ECU detects any problems, the tire pressure warning light blinks (stays on after blinking for 1 minute) and tire pressure monitoring is cancelled at the same time. At this time, the ECU stores a DTC in memory.
Connecting terminals TC and CG of the DLC3 makes the tire pressure warning light blink to output DTCs.
The tire pressure warning ECU and receiver sends the tire pressure warning light illumination request signal to the main body ECU (multiplex network body ECU) via a direct line. The main body ECU (multiplex network body ECU) then sends the signal to the combination meter assembly via CAN communication.

WIRING DIAGRAM


C240093E02


INSPECTION PROCEDURE

NOTICE:
  1. When replacing the tire pressure warning ECU, read the transmitter IDs stored in the old ECU using the Techstream and write them down before removal.
  2. It is necessary to perform initialization (Click here) after registration (Click here) of the transmitter IDs into the tire pressure warning ECU if the ECU has been replaced.
  3. When replacing the tire pressure warning ECU and receiver on vehicles equipped with the wireless door lock control system, be sure to perform Registration of Recognition Code to register the transmitter IDs after ECU replacement (Click here).

1.CHECK FOR DTC (CAN COMMUNICATION SYSTEM)
  1. Check if a CAN communication system DTC is output (Click here).
    Result 
    Result
    Proceed to
    DTCs is not output
    A
    DTCs is output
    B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2.CHECK DTC OUTPUT (B1247)
  1. Clear the DTCs (Click here).

  1. Turn the ignition switch off.

  1. Turn the ignition switch to ON.

  1. Check for DTCs (Click here).

    OK:
    DTC B1247 is not output.



NG
GO TO DTC (B1247)
OK


3.PERFORM ACTIVE TEST USING TECHSTREAM (INDICAT. TIRE PRESSURE WARNING SYSTEM)
  1. Turn the ignition switch off.

  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Body Electrical / Combination Meter / Active Test.

  1. Check the condition of the tire pressure warning light by using the Techstream.

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Indicat. Tire Pressure Warning System
    Tire pressure warning light
    Tire pressure warning light OFF or ON
    Confirm that the vehicle is stopped, engine idling

    OK:
    The tire pressure warning light turns on or off in accordance with the Techstream operation.



NG
GO TO METER / GAUGE SYSTEM (Click here)
OK

REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER (Click here)