Home › Vehicle Interior › SEAT BELT › SEAT BELT WARNING SYSTEM (for Sedan)

SEAT BELT WARNING SYSTEM (for Sedan) > HOW TO PROCEED WITH TROUBLESHOOTING


HINT:
  1. Use these procedures to troubleshoot the seat belt warning system.
  2. *: Use a Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
    1. Use the Techstream to check if the CAN communication system is functioning normally.
      Result: 
      Result
      Proceed to
      DTC is not output
      A
      DTC is output
      B



    B.
    GO TO CAN COMMUNICATION SYSTEM
    A


    4.PROBLEM SYMPTOMS TABLE
      Result: 
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B


    B.
    Go to step 6
    A


    5.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. DATA LIST / ACTIVE TEST (Click here)

    2. TERMINALS OF ECU (Click here)


    NEXT


    6.REPAIR OR REPLACE

      NEXT


      7.CONFIRMATION TEST

        NEXT

        END