ANTI-LOCK BRAKE SYSTEM (for Sedan) > Brake Warning Light does not Come ON |
| 1.CHECK CAN COMMUNICATION SYSTEM |
Check if CAN communication system DTCs are output (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | |
| 2.CHECK BRAKE WARNING LIGHT |
Disconnect the A15 brake actuator assembly (skid control ECU) connector.
Turn the ignition switch to ON.
Check that the brake warning light comes on.
Reconnect the A15 brake actuator assembly (skid control ECU) connector.
|
| ||||
| OK | ||
| ||
| 3.PERFORM ACTIVE TEST USING TECHSTREAM (Indicat. Lamp Brake) |
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
According to the display on the Techstream, perform the Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Indicat. Lamp Brake | Brake warning light | OFF/ON | Perform the test with the vehicle stopped and the engine idling |
Check that the brake warning light on the combination meter turns on or off in accordance with the tester operation.
|
| ||||
| OK | ||
| ||