DTC No.
| DTC Detection Condition
| Trouble Area
|
U0073
| When any of the following is detected:
- When the IG1 terminal voltage is between 10 and 17.4 V, after the output of data from the skid control ECU (brake actuator assembly) is completed, the sending continues for 5 seconds or more.
- The condition that bus OFF state occurs once or more within 0.1 seconds occurs 10 times in succession. (Sent signals cannot be received.)
- When the IG1 terminal voltage is between 10 and 17.4 V, a delay in receiving data from the yaw rate sensor and steering angle sensor continues for 1 second or more.
- When the IG1 terminal voltage is between 10 and 17.4 V, the following occurs 10 times in succession.
- The condition that a delay in receiving data from the yaw rate sensor and steering angle sensor occurs more than once within 5 seconds.
| CAN communication system
|
U0100
| When the IG1 terminal voltage is between 10 and 17.4 V, and the vehicle speed 15 km/h (9 mph) or more, data cannot be received to the ECM for 2 seconds or more.
| CAN communication system
|
U0123
| When either of the following is detected:
- When the IG1 terminal voltage is between 10 and 17.4 V, and the vehicle speed 7 km/h or more, data from the yaw rate sensor cannot be received for 1 second or more.
- When the IG1 terminal voltage is between 10 and 17.4 V, the following occurs 10 times in succession.
- The condition that data from the yaw rate sensor cannot be received occurs once or more within 5 seconds.
| CAN communication system
|
U0124
| When either of the following is detected:
- When the IG1 terminal voltage is between 10 and 17.4 V, and the vehicle speed 7 km/h or more, data from the acceleration sensor cannot be received for 1 second or more.
- When the IG1 terminal voltage is between 10 and 17.4 V, the following occurs 10 times in succession.
- The condition that data from the deceleration sensor cannot be received occurs once or more within 5 seconds.
| CAN communication system
|
U0126
| When either of the following is detected:
- When the IG1 terminal voltage is between 10 and 17.4 V, data from the steering angle sensor cannot be received for 1 second or more.
- When the IG1 terminal voltage is between 10 and 17.4 V, the following occurs 10 times in succession.
- The condition that data from the steering angle sensor cannot be received occurs once or more within 5 seconds.
| CAN communication system
|
U0142
| No communication with main body ECU
| CAN communication system Main body ECU
|