DTC B1795 Occupant Classification ECU Malfunction |
| DTC No. | DTC Detecting Condition | Trouble Area |
| B1795 |
|
|
| 1.CHECK DTC |
Turn the ignition switch to the on position.
Clear the DTCs stored in the memory (Click here).
Turn the ignition switch to the lock position and wait for at least 10 seconds.
Turn the ignition switch to the on position.
Check the DTCs (Click here).
|
| ||||
| NG | |
| 2.REPLACE OCCUPANT CLASSIFICATION ECU |
Turn the ignition switch to the lock position.
Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.
Replace the occupant classification ECU (Click here).
| NEXT | |
| 3.PERFORM ZERO POINT CALIBRATION |
Connect the negative (-) terminal cable to the battery.
Connect the Techstream to the DLC3.
Turn the ignition switch to the on position.
Using the Techstream, perform the zero point calibration (Click here).
| NEXT | |
| 4.PERFORM SENSITIVITY CHECK |
Using the Techstream, perform the sensitivity check (Click here).
Confirm that nothing is placed on the passenger seat.
Confirm that the beginning sensor reading is within the standard range.
Place a 30 kg (66.14 lb) weight (e.g. a lead mass) onto the front passenger seat.
Confirm that the sensitivity is within the standard range.
| NEXT | ||
| ||