POWER WINDOW CONTROL SYSTEM (for Sedan) > Driver Side Power Window does not Operate with Power Window Master Switch |

| 1.INSPECT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (DRIVER SWITCH) |
![]() |
Remove the power window regulator master switch assembly.
Measure the resistance of the switch when the switch is operated.
| Window Lock Switch Condition | Power Window Switch Condition | Tester Connection | Specified Condition |
| Always (ON / OFF) | UP | 1 (E) - 4 (D) 3 (U) - 6 (B) | Below 1 Ω |
| Always (ON / OFF) | OFF | 1 (E) - 3 (U) 1 (E) - 4 (D) | Below 1 Ω |
| Always (ON / OFF) | DOWN | 1 (E) - 3 (U) 6 (B) - 4 (D) | Below 1 Ω |
| Always (ON / OFF) | AUTO DOWN | 1 (E) - 3 (U) 6 (B) - 4 (D) | Below 1 Ω |
Reinstall the power window regulator master switch assembly.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (MASTER SWITCH - MOTOR (DRIVER SIDE)) |
![]() |
Disconnect the G1 power window regulator master switch assembly connector.
Disconnect the G4 power window regulator motor assembly connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| G1-4 (D) - G4-1 | Below 1 Ω |
| G1-3 (U) - G4-2 | Below 1 Ω |
| G1-4 (D) or G4-1 - Body ground | 10 kΩ or higher |
| G1-3 (U) or G4-2 - Body ground | 10 kΩ or higher |
Reconnect the G1 power window regulator master switch assembly connector.
Reconnect the G4 power window regulator motor assembly connector.
|
| ||||
| OK | |
| 3.INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY (DRIVER SIDE) |
![]() |
Remove the power window regulator motor assembly.
Apply battery voltage to connector terminals 1 and 2.
Check that the motor gear rotates smoothly as follows.
| Measurement Condition | Specified Condition |
| Battery positive (+) → 1 Battery negative (-) → 2 | Motor gear rotates counterclockwise |
| Battery positive (+) → 2 Battery negative (-) → 1 | Motor gear rotates clockwise |
Reinstall the power window regulator motor assembly
|
| ||||
| OK | ||
| ||