OCCUPANT CLASSIFICATION ECU (for Sedan) > INSTALLATION |
| 1. INSTALL OCCUPANT CLASSIFICATION ECU |
Check that the ignition switch is turned OFF.
Check that the negative (-) battery terminal is disconnected.
Install the occupant classification ECU.
Connect the connectors to the occupant classification ECU.
| 2. INSTALL FRONT SEAT ASSEMBLY RH |
![]() |
Insert the 2 locating pins through the 2 body holes, place the front seat in the most forward position, and then make sure that the inner and outer seat tracks are locked securely.
Using an E10 "TORX" socket wrench, tighten bolt 1 and then bolt 2 on the rear side.
Move the front seat to the most rearward position, and then make sure that the inner and outer seat tracks are locked securely.
Using an E10 "TORX" socket wrench, tighten bolt 3 and then bolt 4 on the front side.
Connect the occupant detection ECU connector.
Connect the buckle switch connector.
Install the clamp.
| 3. INSTALL FRONT SEAT HEADREST ASSEMBLY |
Push in the lock button of the front seat headrest support and install the front seat headrest.
| 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 5. PERFORM OCCUPANT CLASSIFICATION ECU INITIALIZATION |
| 6. INSPECT SRS WARNING LIGHT |