THEFT DETERRENT SYSTEM (for Sedan) > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.INSPECT BATTERY VOLTAGE |
| |||||
| 3.CHECK FOR DTC |
Check for DTCs and note any codes that are output.
Delete the DTCs.
Check whether the same DTCs recur by simulating the conditions indicated by the DTCs noted in step (a) above.
If no DTCs recur, proceed to A.
If the same DTCs recur, proceed to B.
|
| ||||
| |||||
| 4.PROBLEM SYMPTOMS TABLE |
If the fault is not listed in the problem symptoms table, proceed to A.
If the fault is listed in the problem symptoms table, proceed to B.
|
| ||||
| |||||
| 5.OVERALL ANALYSIS AND TROUBLESHOOTING |
Data list/Active test (Click here)
Terminals of ECU (Click here)
System Description (Click here)
| |||||
| 6.ADJUST, REPAIR OR REPLACE |
| |||||
| 7.CONFIRMATION TEST |
|
| ||||
|---|---|---|---|---|---|