Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM (for Sedan)

THEFT DETERRENT SYSTEM (for Sedan) > Engine Hood Courtesy Switch Circuit


DESCRIPTION

The engine hood courtesy switch is built into the engine hood lock assembly. The switch turns on when the engine hood is opened and turns off when the engine hood is closed.

WIRING DIAGRAM


B148196E24


INSPECTION PROCEDURE

1.READ VALUE USING TECHSTREAM (ENGINE HOOD COURTESY SWITCH)
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the tester ON.

  1. Select the item below in the Data List and read the display on the tester.

    Theft Warning ECU:

    Item
    Measurement Item/Display (Range)
    Normal Condition
    Diagnostic Note
    Hood Courtesy Switch
    Engine hood courtesy switch signal/ON or OFF
    ON: Engine hood is OPEN
    OFF: Engine hood is CLOSED
    -



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE 

2.INSPECT HOOD LOCK ASSEMBLY (ENGINE HOOD COURTESY SWITCH)


    E107106E01
  1. Disconnect the A18 courtesy switch connector.

  1. Check the resistance of the engine hood courtesy switch.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Lock
    (OFF)
    10 kΩ or higher
    1 - 2
    Unlock
    (ON)
    Below 1 Ω

  1. Reconnect the courtesy switch connector.



NG
REPLACE HOOD LOCK ASSEMBLY (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (THEFT WARNING ECU ASSEMBLY - ENGINE HOOD COURTESY SWITCH)


    B121330E01
  1. Disconnect the D26 theft warning ECU and A18 engine hood courtesy switch connectors.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    D26-4 (DSWH) - A18-2 (CTYH)
    Below 1 Ω
    D26-4 (DSWH) - Body ground
    10 kΩ or higher

  1. Reconnect the theft warning ECU and engine hood courtesy switch connectors.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (ENGINE HOOD COURTESY SWITCH - BODY GROUND)
  1. Disconnect the A18 engine hood courtesy switch connector.



    B121331E01
  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    A18-1 (GND) - Body ground
    Below 1 Ω

  1. Reconnect the engine hood courtesy switch connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE THEFT WARNING ECU ASSEMBLY (Click here)