THEFT DETERRENT SYSTEM (for Sedan) > Unlock Warning Switch Circuit |

| 1.CHECK FOR DTC |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON and turn the tester ON.
Clear the DTCs.
Check whether DTC B1269 recurs 10 seconds or more after the ignition switch is turned ON.
|
| ||||
| OK | |
| 2.READ VALUE USING TECHSTREAM (UNLOCK WARNING SWITCH) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the tester main switch ON.
Select the item below in the Data List and then read the display on the tester.
| Item | Measurement Item/Display (Range) | Normal Condition | Diagnostic Note |
| Key SW | Unlock warning switch signal ON/OFF | ON: Key is inserted into ignition key cylinder OFF: Key is removed from ignition key cylinder | - |
|
| ||||
| OK | ||
| ||
| 3.INSPECT UNLOCK WARNING SWITCH ASSEMBLY |
![]() |
Remove the unlock warning switch assembly.
Measure the resistance.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | Pushed (ON (Key inserted)) | Below 1 Ω |
| 1 - 2 | Not pushed (OFF (Key removed)) | 10 kΩ or higher |
Reinstall the unlock warning switch assembly.
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (THEFT WARNING ECU ASSEMBLY - UNLOCK WARNING SWITCH ASSEMBLY) |
![]() |
Disconnect the D26 theft warning ECU and the D19 unlock warning switch connectors.
Measure the resistance.
| Tester Connection | Specified Condition |
| D26-7 (KSW) - (D19-1) | Below 1 Ω |
| D26-7 (KSW) - Body ground | 10 kΩ or higher |
Reconnect the theft warning ECU and the unlock warning switch connectors.
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (UNLOCK WARNING SWITCH ASSEMBLY - BODY GROUND) |
Disconnect the D19 unlock warning switch connector.
![]() |
Measure the resistance.
| Tester Connection | Specified Condition |
| D19-2 - Body ground | Below 1 Ω |
Reconnect the unlock warning switch connector.
|
| ||||
| OK | ||
| ||