RADIO ANTENNA CORD (for Sedan) > REMOVAL |
| 1. REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY |
| 2. REMOVE INSTRUMENT CLUSTER CENTER FINISH PANEL SUB-ASSEMBLY |
![]() |
Disengage the 2 claws and 4 clips and remove the instrument cluster finish panel center.
| 3. REMOVE STEREO OPENING COVER |
![]() |
Remove the 4 screws and the stereo opening cover.
| 4. REMOVE ANTENNA CORD SUB-ASSEMBLY |
Remove the bolt, the hook and the bracket.

| *a | Hook | *b | Clamp |
Using a clip remover, remove the clamp.
Disconnect the antenna amplifier connector.
Remove the 5 clamps and the antenna cord.
| 5. REMOVE ROOF HEADLINING ASSEMBLY |
| 6. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY |
Remove the 6 pieces of tape.

Remove the No. 2 antenna cord from the 6 claws of the front and rear side rail spacers.