DTC P0724 Brake Switch "B" Circuit High |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0724 | The stop light switch remains on even when the vehicle repeats 5 cycles of STOP (less than 3 km/h [1.86 mph]) and GO (30 km/h [18.65 mph] or more) (2 trip detection logic). |
|
| Related DTCs | P0724: Stop Light Switch/Range Check/Rationality |
| Required Sensors/Components (Main) | Stop light switch assembly |
| Required Sensors/Components (Related) | Speed sensor |
| Frequency of Operation | Continuous |
| Duration | GO and STOP 5 times |
| MIL Operation | 2 driving cycles |
| Sequence of Operation | None |
| Monitor runs whenever following DTCs not present | None |
| Battery voltage | 8 V or higher |
| Starter | OFF |
| Ignition Switch | ON |
| GO: 30 km/h (18.65 mph) or more | Once |
| STOP: Less than 3 km/h (1.86 mph) | Once |
| Brake pedal position switch | ON |

| Techstream Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.READ VALUE USING TECHSTREAM (STOP LIGHT SWITCH) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Data List / Stop Light Switch.
Read the values displayed on the Techstream.
| Techstream Display | Measurement Item/Range (display) | Normal Condition |
| Stop Light Switch | Stop light switch status: ON or OFF |
|
|
| ||||
| OK | ||
| ||
| 2.CHECK STOP LIGHT SWITCH ASSEMBLY INSTALLATION |
Check the stop light switch assembly installation .
|
| ||||
| OK | |
| 3.INSPECT STOP LIGHT SWITCH ASSEMBLY |
Inspect the stop light switch assembly (Click here).
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (STOP LIGHT SWITCH ASSEMBLY - ECM) |
Disconnect the ECM connector.
![]() |
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A72-9 (STP) - Body ground | Brake pedal released | 0 to 1.5 V |
| Brake pedal depressed | 7.5 to 14 V |
| *a | Brake pedal depressed |
| *b | Brake pedal released |
| *c | Front view of wire harness connector (to ECM) |
|
| ||||
| OK | ||
| ||