Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT PASSENGER AIRBAG ASSEMBLY (for Sedan)

FRONT PASSENGER AIRBAG ASSEMBLY (for Sedan) > INSTALLATION


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).



1. INSTALL INSTRUMENT PANEL WIRE ASSEMBLY


    B108297E02
  1. Connect the 2 airbag connectors to install the instrument panel wire.
    Text in Illustration 
    *a
    Locking Button

    NOTICE:
    Lock the locking button securely.



2. INSTALL FRONT PASSENGER AIRBAG ASSEMBLY
  1. Engage the 10 hooks so that the connector side faces the outside of the vehicle, and install the front passenger airbag.

  1. Install the wire harness onto the 2 claws of the instrument panel.



3. INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY
(Click here)


4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



5. CHECK SRS WARNING LIGHT
(Click here)