Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT PASSENGER AIRBAG ASSEMBLY (for Sedan)

FRONT PASSENGER AIRBAG ASSEMBLY (for Sedan) > REMOVAL


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



3. REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY
(Click here)


4. REMOVE FRONT PASSENGER AIRBAG ASSEMBLY


    B349260
  1. Remove the wire harness from the 2 claws of the instrument panel.

  1. Disengage the 10 hooks and remove the instrument panel passenger airbag.



5. REMOVE INSTRUMENT PANEL WIRE ASSEMBLY


    B108296E02
  1. Using a thin-bladed screwdriver, release the locking button.
    Text in Illustration 
    *a
    Locking Button

  1. Using a thin-bladed screwdriver, disconnect the 2 airbag connectors and remove the instrument panel wire.