DTC C1381 Acceleration Sensor Power Supply Voltage Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1381 | At a vehicle speed of more than 3 km/h (2 mph), the acceleration sensor power source malfunction signal is received for 10 seconds or more. |
|
| 1.CHECK TERMINAL VOLTAGE (IG2 TERMINAL) |
![]() |
Disconnect the yaw rate and deceleration sensor (airbag sensor assembly) connector.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D112-21 (IG2) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector (to Yaw Rate and Deceleration Sensor (Airbag Sensor Assembly)) |
Turn the ignition switch off.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (GND TERMINAL) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D112-25 (E1) - Body ground | Always | Below 1 Ω |
| D112-26 (E2) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Yaw Rate and Deceleration Sensor (Airbag Sensor Assembly)) |
Reconnect the yaw rate and deceleration sensor (airbag sensor assembly) connector.
|
| ||||
| OK | |
| 3.RECONFIRM DTC |
Clear the DTC (Click here).
Start the engine.
Perform a road test.
Check if the same DTC is recorded (Click here).
| Result | Proceed to |
| DTC C1381 is not output | A |
| DTC C1381 is output | B |
|
| ||||
| A | ||
| ||